Inground Full Rise Scissor Lift "Los Angeles" ( opt. above-ground)

Special features of "Los Angeles" XX81

• 1A processing quality with CE certificate for UVV acceptance
• Production according to ISO 9001
• Control panel almost only with branded goods
• Bolts and screws galvanized
• Wheel-free jack with lockable ramps for a longer pickup area
• hose rupture protection
• Hochwertige Pulverbeschichtung von DUPONT
• Bolts and screws hot-dip galvanized
• Two-wall compressed air cylinder for less wear
• CE stop and signal tone when lowering (foot protection), acoustic lowering protection, acoustic warning device
• Anti-trap protection according to Euro standard (EN)
• Hydraulic synchronization control/ synchronization regulation (cylinder sequence principle)
  Automatic safety locking and unlocking - pressure force of 10 bar is required
• Hydraulic shut-off valve
• overload valve
• Lowering safety device
• Automatic locking safety latches
• Roadway with ramps and roll-off protection
• Emergency lowering system in case of power failure

Are you looking for a drive-on scissor lift for underfloor body works? No need to anymore! With a maximum lifting height of gigantic 2.05m (without wheel-free jack) and a lifting time of a rapid 75 seconds, a scissor lift from Krömer is simply a must for almost all maintenance work on tires and lower body parts. This Krömer professional drive-on scissor lift is perfectly equipped for underfloor installation. Of course, a ground-level installation without digging is also possible as an alternative. With a load capacity of 4,000 kg, our XX81 "Los Angeles" model carries everything except caravans.

By purchasing drive-on ramps, the XX81 "Los Angeles" double lifting platform can optionally also be used as a transfer platform.

In addition, this Krömer scissor lift is also perfect as a receiving platform. With the associated LED light, you always have an overview.

Working with your new XX81 double lift should remain stress-free for you. Ascending and decending the scissors is easy with push button controls on the control panel!

Does your car have a longer wheelbase? No problem for Kromer! Due to its particularly large drive-on platforms with a huge length of 4.50 m, the XX81 can lift any body, no matter how huge.

The areas of application of our lifting platform are very diverse due to the wide range of vehicle models and their mounting points.We would like to point out that the application pictograms given are only and exclusively intended as a guide and do NOT reflect the actual absorption capacity of our products. KHG Krömer's Handelsgesellschaft mbH assumes no liability that all models of the corresponding vehicle class can be accommodated.

The Krömer full rise scissor lift is very well equipped for wheel alignment. The particularly long wheel-free jack (18200 mm) makes work on the wheel axles easier. Of course, this stage also has a detachable ratchet system as well as rear swing plates and recesses for turntables. This allows you to work quickly and efficiently. Cross-adjustable, lockable sliding panels complete the Krömer package.

The XX81 ensures precise work. The scissors are evenly ascended and descended by a hydraulic equalizer. In addition, this scissor lift has a light barrier for synchronization control.

The "Los Angeles" - XX81 scissor lift has been tested and approved in accordance with the Machinery Directive in accordance with Annex IV and is therefore equipped with a CE certification from one of the leading testing agencies that deals exclusively with lifts.

In addition to the usual CE regulations, both the platform and the control panel were tested separately for functionality before they were sold.

Notice!

In addition to a compressor (at least 10 bar), you also need hydraulic oil* (25 liters required, observe the operating instructions) for the first start-up. A forklift should also be available for delivery.